A smart lock installation should begin with the door, not the app. Confirm that the deadbolt moves freely when the door is both open and closed. Measure the backset and door thickness against Yale’s compatibility requirements, and identify which side of the door is outside. Keep the existing key and hardware nearby until the new lock has completed several successful tests.

Remove the old deadbolt without allowing the exterior parts to fall. Install the new latch in the correct orientation, feed the cable through the opening, and keep the exterior keypad level while attaching the interior mounting plate. Connect the cable gently and avoid pinching it behind the lock body. Tighten screws evenly; excessive force can distort the mechanism and cause calibration problems.

Install the Yale application specified for the model and region on Android or iPhone. Create the owner account, scan or select the lock, and follow the handedness and calibration prompts with the door open. Install any required Wi-Fi module or bridge exactly as directed. Update firmware before inviting other users or connecting voice assistants.

Create individual entry codes instead of one code shared by everyone. Temporary codes are better for guests, cleaners, or contractors because they can be removed without affecting family access. Enable notifications for manual and code-based unlocking, but avoid displaying sensitive code details in notification previews. Keep a physical fallback available and replace batteries promptly when the app reports a low level.

The Best Buy installation video demonstrates the Yale Assure Lock 2 Keypad with Wi-Fi from physical setup through connected configuration. Interface names can vary by region and software version, so use the video for the installation sequence and follow the current prompts shown in the official Yale app.

Source: www.youtube.com